Nozzle for the E3D Hotend with a Wear Resistant Twin Clad coating for long life
FeaturesSpecsSupport
This is RepRap style nozzle, it is made in the USA by Micro-Swiss from a 360 brass base material and plated with TwinClad XT coating. TwinClad XT is a nickel composite coating designed for very low friction. It offers one of the lowest coefficient of friction, better then nickel with PTFE codeposit. This coating is also very hard and abrasion resistant. If you are working with abrasive filaments like Carbon Fiber, Aluminates or metal filled, this will greatly improve the life of your nozzle. Available for 1.75mm and 3mm filament.
- Thread Type: M6 x 1
- Thread Length: 7.5mm
- Overall Length: 13mm
- Head Length: 5.5mm
- Head width (across flats): 7mm
Product Dimensions: 12 x 7 x 7mm
Next >
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Hot End - E3D v6 clone - 1.75mm Filament, 0.4mm nozzle - Direct Drive
This complete hot end is based on the J-Head design as modified by E3D (V6). Includes everything you need, hot-end wise for 1.75mm filament.Note this is a PTFE lined system
Designed for extruders using direct drive filament feeding (2mm hole at top)
Nozzle for the E3D Hotend with a Wear Resistant Twin Clad coating for long life
Buy Now
Hot End - E3D v6 clone - 1.75mm Filament, 0.4mm nozzle
This complete hot end is based on the All-Metal J-Head design as modified by E3D (V6). Includes everything you need, hot-end wise for 1.75mm filament
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $15
Sydney - Kingsgrove, NSW
Melbourne - Clayton, VIC
