Prices + Stock updated 24 Apr @ 16:30
This aftermarket heat block allows you to push your E3D Volcano style hotend over 500 degrees!
- (Cartridge Style Thermistors only)
NOTE: Use with a PT100 thermocoupler, which is suited to these higher running temperatures without losing accuracy. If planning to use at regular temperatures (up to 300degrees), then a standard thermocoupler is OK.
Suitsa M6 nozzles and barrel / heatbreaks
- (Cartridge Style Thermistors only)
Next >
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Related Products:
Buy Now
0.8mm Nozzle - M6 Thread for Volcano Hotend - Stainless Steel - 1.75mm Filament
Aftermarket 0.8mm Nozzle for Volcano Hotend
Buy Now
0.4mm Nozzle - M6 Thread for Volcano Hotend - Stainless Steel - 1.75mm Filament
Aftermarket 0.4mm Nozzle for Volcano Hotend
Buy Now
Silicon Sock - Heater Block Cover for Volcano v2
Aftermarket heater block cover for E3D Volcano hot end
Buy Now
Heater Block for Volcano Hot Ends - Updated
Aftermarket Heater Block for Volcano Hot Ends - (Cartridge Style Thermistors only)
Buy Now
Duet3D PT-100 High-Temp Sensor with interface board
This sensor and adapter board not only makes temperature sensing more accurate, it also allows you to measure up to 500 °C
Buy Now
Hot End - Volcano Clone - 1.75mm filament, 0.6mm nozzle, 24V
Volcano compatible all metal hotend
Copyright 2011-2024 Bilby3D Pty. Ltd.