Micro Swiss All Metal Hotend Kit Features:

All metal hotend upgrade for MK10 style extruders. This upgrade includes a modified thermal barrier tube and modified nozzle with modified cooling block. Thermal barrier tube is made from 2 different materials. The lower thermal break is made from stainless steel, and the colder upper part is made from aluminum. Stainless steel was used for thermal break because it offers low thermal conductivity, and aluminum was used for the upper portion because it has a lot better thermal conductivity, to carry away any heat from the filament. All metal hotend will let you print at much higher temperature than possible with original PTFE lined one. Another benefit of an all metal hotend design is more consistent melt chamber control. During slow extrusion rate, in PTFE lined hotend, transition zone from solid to molten plastic tends to creep upward creating more stringy prints. With all metal design a transition zone is always constant, being located right at the heat break. With fast extrusion rate, PTFE tube doesnt have enough thermal conductivity to properly melt all the plastic coming out. On MK10 extruders that limitation happens around 60 mm/s, depending on nozzle size. All metal hotend solves this problem, plastic is surrounded by thermally conductive nozzle throughout its length.

Kit will fit:
- Wanhao i3
- Wanhao i3 Plus
- Monoprice Maker Select 3D Printer v2
- Monoprice Maker Select Plus
- Cocoon Create 3D Printer

Kit includes
- 1 Brass Wear Resistant Plated Nozzle (0.4mm hole)
- 1 Thermal tube
- 1 Slotted Cooling block



Next >

Barrel and Nozzle are the same as per our MK10 upgrade kit (search for ptKitMK10TC)
Replacement Twin Clad nozzles available in 0.2, 0.3, 0.4, 0.6, 0.8 1.0 and 1.2mm hole sizes (ptNozzle02MK10TC etc)

Dimensions: 42.1x39.12.9


Next >

This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product