Prices + Stock updated 10 May @ 13:42
This Polyimide (also known as Kapton) Tape is a high temperature insulative tape. It uses a silicon based adhesive to withstand high temperatures up to 260 C.
This tape is great around your extruder head where things get over 210 C. It can also be used as a general purpose electrical tape. It is anti-static and designed to leave no adhesive residue. The roll is approx 30m long and kapton is approx 0.02mm thick
Next >
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Related Products:
Buy Now
Polyimide - 20mm wide - 30m long
Polyimide / Kapton Tape, 20mm wide.
The roll is approx 30m long and kapton is approx 0.05mm thick
Buy Now
Polyimide (Kapton) Tape - 100mm wide - 30m long
This Polyimide (also known as Kapton) Tape is extra wide (100mm), great for covering your build platform when printing with ABS. The roll is approx 33m long and Kapton is approx 0.02mm thick
Buy Now
Polyimide (Kapton) Tape - 50mm wide - 30m long
This Polyimide (also known as Kapton) Tape is great for covering your build platform or providing electrical insultation. ABS stick to this when hot (with a heated bed), but releases easily when cold.
Buy Now
Polyimide (Kapton) Tape - 200mm wide - 33m long
This Polyimide (also known as Kapton) Tape is extra wide (200mm)
The roll is approx 33m long and kapton is approx 0.02mm thick
Buy Now
Ceramic tape with Kapton for Finder, Inventor2, Guider2 - UNTIL SOLD OUT
Suits the Finder, Inventor2, Inventor2s, Inventor2SE, Guider, Guider2 and Guider2s machines as well as many others. It is not self adhesive and you need Kapton tape to attach to the heater block.
Buy Now
Pre-Cut Ceramic tape with Kapton - UNTIL SOLD OUT
Suits the Creator Pro, Dreamer and Inventor machines as well as a wealth of others. It is not self adhesive and you need Kapton tape to attach to your heat block.
Buy Now
Ceramic Insulation Tape
This 1 inch wide ceramic tape is used to wrap your heater block and reduce heat transfer to both the extruder and your work piece. Fix by wrapping in kapton tape.
The tape on your Reprap will need replacing from time to time, especially when a print fails and the melted plastic gets caught up in the print head - it can sometimes stick to the ceramic tape and rip it on removal - careful not to pull on the temperature sensor wire!
Buy Now
Heater Cartridge - 40W 24V
This ceramic core heater cartridge has a variety of heating possibilities from hot ends/ extruders to heated beds.
Buy Now
Heater Cartridge - 40W 12V
This ceramic core heater cartridge has a variety of heating possibilities from hot ends/ extruders to heated beds.
Suitable for CR-10 Machines.
Copyright 2011-2024 Bilby3D Pty. Ltd.