Note: This kit is not suitable for Guider2 / Guider 2S with the High Temp Hotend. The HT has a shorter thread in the heatsink. You can only use this kit with the original heatsink, which can be purchased separately - ptExtHSinkFFg2.

This upgrade includes a modified thermal barrier tube (barrel) and modified nozzle.

Thermal barrier/barrel tube is made from 2 different materials. The lower thermal break is made from stainless steel, and the colder upper part is made from aluminum. Stainless steel was used for thermal break because it offers low thermal conductivity, and aluminum was used for the upper portion because it has a lot better thermal conductivity, to carry away any heat from the filament.

The Nozzle is a TC (tough coat) nozzle, that is abbrassive filament resistent and perfect for metal filaments like Bronze and stainless steel.
Replacement code for this nozzle is : ptNozzle04MK10TC. Also available in 0.2,0.3,0.6 and 0.8mm sizes

Why install this upgrade?
This all metal hotends will let you print at much higher temperature than possible with original Flashforge PTFE lined system.

-Another benefit of an all metal hotend design is more consistent melt zone control. During slow extrusion rate, in PTFE lined hotends, the transition zone from solid to molten plastic tends to creep upward creating more stringy prints. With all metal design a transition zone is always constant, being located right at the heat break. With a fast extrusion rate, PTFE tube doesnt have enough thermal conductivity to properly melt all the plastic coming out. On MK10 extruders that limitation happens around 60 mm/s, depending on nozzle size.

-Lower Maintainence as you no longer need to worry about replacing the PTFE lining. The all metal barrel/thermal barrier eliminates this.



Next > More Information

The all metal hotend solves this problem, plastic is surrounded by thermally conductive nozzle throughout its length.
Kit includes 1 nozzle and 1 (2 part) thermal tube.

Suits:

• FlashForge Finder
• FlashForge Finder Plus
• FlashForge Inventor 2
• FlashForge Inventor 2S
• FlashForge Inventor 2SE
• FlashForge Guider
• FlashForge Guider 2 - Remove metal nozzle cover for increased veltilation
• FlashForge Guider 2S - Remove metal nozzle cover for increased veltilation
• Dremel 3D40 Idea Builder

Note: This kit is not suitable for Guider2 / Guider 2S with the High Temp Hotend. The HT has a shorter thread in the heatsink. You can only use this kit with the original heatsink, which can be purchased separately - ptExtHSinkFFg2.


Dimensions: 27 x 8 x 8mm


Next >

IMPORTANT: after fitting you must run Nozzle calibration and re-level functions from LCD screen. Please read this article



Note: When fully assembled the length should be around 47.1mm (Barrel tip to nozzle tip before fitting heat sink), then once the heatsink attached the overall length is around 57.9mm (55.0 for inventor2 heatsink)
Bilby 3D provides a 1 month Australian, back-to-base warranty of this product (Terms and conditions)
For technical support of this product please read our knowledge bank or log a ticket