Prices + Stock updated 10 May @ 13:42
These metal fittings are used for holding pneumatic (compressed air) tube. Designed for tube with a 4mm diameter made of Nylon or PU (PolyUrethane), they also work better than anything else we have found with PTFE tubing, which is very hard to hold due to its low friction. Has plastic collar - push down to release.
These are great for bowden tube style extruders, or anywhere else you need to hold a filament feeder tube securely.
Next >
Suitable for: Filament feeder tubes, air or vacuum hoses
Pressure: 0 - 1.0 MPa
Vacuum: -750mmHg
Max Pressure: 1.5MPa
Outer Thread: 3/8inch dia. 1/8pitch (standard air compressor size)
Thread Length: ~7.75mm
Overall Length: 20mm
Spanner Size: 10mm across flats
Dimensions: 20x10x12
Next >
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Related Products:
Buy Now
Teflon Tube - 2mm ID, 4mm OD - For 1.75mm Filament
Teflon (PTFE) tube is used to make filament feeder and Bowden tubes.
Buy Now
Push-In Hose Fitting - for 4mm tube, M6 Thread
These metal fittings are used for holding pneumatic (compressed air) tube. Designed for tube with a 4mm diameter made of Nylon or PU (PolyUrethane), they also work better than anything else we have found with PTFE tubing, which is very hard to hold due to its low friction. Has plastic collar - push down to release.
Buy Now
Bulldog Lite Extruder - 1.75mm - Until Sold Out
This tough little extruder includes everything you need to take filament from you spool through to pushing it into your hotend
Buy Now
Bulldog XL Extruder - 1.75mm - Until Sold Out
This tough extruder includes a greabox for extra filament feeding torque as well as everything you need to take filament from you spool through to pushing it into your hotend.
Buy Now
Hexagon Hot End Set for 1.75mm Filament
This complete hotend kit from RepRap discount includes; nozzle, heater block, barrel/heat barrier, fined heat sink, heater cartridge, thermistor, fan, mount and more in a plastic case
Buy Now
Push-In Hose Fitting - for 4mm tube, M10 Thread
These metal fittings are used for holding pneumatic (compressed air) tube. Designed for tube with a 4mm diameter made of Nylon or PU (PolyUrethane), they also work better than anything else we have found with PTFE tubing, which is very hard to hold due to its low friction. Has plastic collar - push down to release.
Copyright 2011-2024 Bilby3D Pty. Ltd.