Custom made by Micro-Swiss for Bilby3D, this all metal hotend upgrade for the FlashForge Finder, FinderPlus and Inventor2 has a thicker barrel to reduce damage during fitting and and operation

Genuine Micro-Swiss all metal hotend upgrade for the FlashForge Guider, Guider 2
Finder, FinderPlus and Inventor2 recomend - ptKitMK10TC3 Comes with 0.4mm nozzle, range of other sizes available

Genuine heater block for the FlashForge Finder series, Guider Series and Inventor 2

Genuine FlashForge replacement part

Genuine FlashForge thermocoupler with 11cm lead length and Molex connector for the Finder, Inventor2 and Guider Series which have a terminal board on the extruder carriage.

Genuine FlashForge replacement part for the Guider 2 (NOT THE GUIDER 1-see specs tab), Inventor 2/2S/2SE

This cover goes over the heater block to keep the heat where it is meant to be.

Suits the Finder, Inventor2, Inventor2s, Inventor2SE, Guider, Guider2 and Guider2s machines as well as many others. It is not self adhesive and you need Kapton tape to attach to the heater block.

This machine is Second Hand. It has been thoroughly tested and serviced by Bilby3D so we offer a 30day warranty on this machine

This is a special Edition of the FlashForge Inventor 2 is the product of a collaboration between Bilby 3D, Flashforge, and Microswiss that upgrades the Inventor 2 to meet the demands of the Education environment, with significantly decreased maintenance requirement and easy use. In addition it is ready for almost any material straight out of the box including Metal filaments.