Prices + Stock updated 10 May @ 13:42
Genuine Sensor / Endstop Board and Switch (Flashforge brand)
Also Makerbot Replicator 2 and 2X models
Related Products:
Buy Now
Z Axis endstop for FlashForge Dreamer/Finder
Genuine Z-Axis (Build Platform) Endstop Board for the FlashForge Dreamer Series, and Y endstop on the Finder
Buy Now
Makerbot R2/2X- End stop cable (cable D) (rev 2) - UNTIL SOLD OUT
This cable is used to connect the X Y and Z endstop boards to the motherboard. It is used on the Markerbot Replicator Rev H (post sept 2013) 2 and 2 X machines, and includes 3 ferrits pre-fitted.
IMPORTANT : This version is for Rev H motherboards. Not rev G - pre oct 2013. Also the X length is only 90cm long and requires an Endstop Jumper cable to be purchased separately.
Not used on the Replicator 1 Ply wood models, or rev G machines. If you have a rev G Replicator 2 or 2x - pre oct 2013 edition, those cables are now discontinued. You can fit this version with the jumpercable just ferrites are a bit tight for space under base plate.
This is the cable only and does not include the endstop boards
Buy Now
Makerbot Replicator 2/2X -X Endstop Jumper Cable
This ribbon cable extrends the X Endstop cable. It connects to the X endstop and the XYZ endstop cable, providing extra length at the X motor end. All rev H Motor cables require this extrension.
Buy Now
FlashForge Endstop Cable
This endstop cable is for FlashForge Dreamer series of 3D Printers. One spare comes with the printer. It will fit either the X, Y or Z endstop boards (endstop board sold separately)
Copyright 2011-2024 Bilby3D Pty. Ltd.