Prices + Stock updated 10 May @ 13:42
Genuine Flash forge Level sensor Motor
Fits Guider, Finder and Inventor series printers
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Related Products:
Buy Now
FlashForge Bed Level Sensor Board (Guider / Finder / Inventor 2)
This is the sensor that detects the bed on a Guider, Guider2, Finder and Inventor 2. It is screwed onto the sensor arm, which is then attached the the motor (both sold seperately). It can get broken if level is very out or in cases of extreem print fails. BE AWARE older editionsl of original Guider use a square board, not this part-see PTsensorFF.
Buy Now
FlashForge Bed Sensor Arm (Guider / Finder)
This Arm pivots down on the Guider, Inventor 2/2SE and Finder with the level sensor screwed on to it.
The arm attaches to the Bed sensor motor.
DOES NOT WORK/FIT ON A GUIDER 2, see ptSensorBedArmFFG2. This arm differs from that arm as the spoon area is squared. The Guider 2 one has a cut out in the top right of the spoon.
Buy Now
FlashForge Bed Sensor Arm (Guider2 / 2s)
This Arm pivots down on the Guider 2, with the level sensor screwed on to it.
The arm attaches to the Bed sensor motor.
DOES NOT WORK/FIT ON A GUIDER 1, Inventor 2/2SE and Finder, see ptSensorBedArmFF. This arm differs from that arm are in that it has a cut out in the top right of the spoon.
Copyright 2011-2024 Bilby3D Pty. Ltd.
Sydney - Kingsgrove, NSW
Melbourne - Clayton, VIC
Perth - Belmont, WA
3D Printers
Bilby 3D Technical Support
3D Printer Service and Repair
Courses and Training
Materials / Filament
3D Scanners
Parts and Spares
Tools & Jigs