Prices + Stock updated 10 May @ 13:42
This linear bearing suits an 8mm shaft, and differs from the more common LM8UU in that the body is shorter.
It is 17mm long, outer diameter 15mm.
This is the same sized bearing used in the Makerbot Replicator, but it is not a genuine Makerbot part. It is also a snap in replacement for the bronze bushings in the X and Y axis of the Replicator 2 and 2X.
Next >
The gap between the two circlip grooves is about 9.5mm
Fundamental load rating is 74N, static load rating is 147N
Dimensions: 15x15x17mm
Next >
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Related Products:
Buy Now
Linear Bearing for 8mm shaft
Linear bearings help an axis to move freely and precisely
Buy Now
Linear Bearing for 8mm shaft - 10 Pack
Linear bearings help an axis to move freely and precisely
Buy Now
Linear Bearing for 8mm shaft, long version
This long linear bearing is suitable for a variety of CNC projects
Buy Now
Linear Bearing Block for 8mm shaft, Aluminium
These linear bearing blocks hold two LM8UU bearings (fitted, with circlips) with a grease nipple in between.
They are designed to run on 8mm shaft.
Buy Now
Linear Bearing Block for 8mm Shaft - 1 x LM8UU Bearing
These linear bearing blocks hold one LM8UU bearing (included, with circlips) in an anodised Aluminium housing.
Copyright 2011-2024 Bilby3D Pty. Ltd.