Prices + Stock updated 10 May @ 13:42
Thermistor Cable for measuring the temperature of Hot ends and heated beds on Reprap, Prusa i3 and similar
1.3mm diameter glass thermistor on 1meter cable with bare ends
Next >
1.3mm dia. Glass bead NTC 3950 thermistor
High Accuracy: 1%
Resistance value at 25°C: 100K
Thermistor value table already in Marlin firmware
Insulation: High Temp PTFE
Fits snugly in to thermistor hole of ptHeatBlock16 (16mm square heat block)
DOES NOT fit thermistor hole in ptHeatBlockM3D (20mm square heat block) - though the fixing screw will hold it against the heat block for measurement, or the hole could be enlarged. Just not as neat.
Apply Heat Grease to improve contact if required.
Dimensions: 1000mm x 1.3mm x 2.2mm
Next >
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Copyright 2011-2024 Bilby3D Pty. Ltd.