Prices + Stock updated 10 May @ 13:42
The Duex 5 expasion board allows you to run 5 stepper motors, heater cartridges, thermistors and endstops. It also has 6 controlled fan outputs.
The Duex5 has the following features:
- 5 additional TMC2660 stepper motor drivers with stall notification.
- 5 additional extruder heater outputs.
- 5 servo outputs with 5V power and 5V signal levels, sharing control channels with the heaters, so you can use unused heater channels to drive servos.
- 5 additional endstop inputs with indicator LEDs and 3.3V/5V voltage selection. These are also usable as outputs.
- 6 additional controlled fan outputs, also usable for driving LEDs etc. The output voltage may be switched between 5V, 12V and VIN.
- 4 uncommitted general purpose I/O pins.
- 12V switching regulator, for generating a 12V supply for fans, LEDs etc. when the VIN power is higher than 12V.
- 5 additional thermistor inputs.
- Support for 2 more thermocouple or PT100 daughter boards, supporting up to 4 more sensors.
- Optional 5V external power input for powering servos, fans etc.
The Duex2 has the same feature list, just with 2 channels of TMC on board strepper drivers, rather than 5. Both are supplied with the 50 way connector cable between the DuetWifi and the Duex.
Next >
More Information
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Related Products:
Buy Now
Duet2 Wifi Controller Board v1.04
Duet 2 Wifi is an advanced 32 bit electronic controller for 3D printers and other CNC machines. It has the same features as the Duet 2 Ethernet other than providing WiFi connectivity rather than ethernet - External Aerial Version
Buy Now
Rotating Magnet Filament Monitor for Duet3D Printer Control Electronics
Finally a filament sensor that detects whether the filament is moving!
The magnetic rotary encoder will sense filament presense and movement, so ven knotted spools can be detected.
Buy Now
Duet3D PT-100 High-Temp Sensor with interface board
This sensor and adapter board not only makes temperature sensing more accurate, it also allows you to measure up to 500 °C
Copyright 2011-2024 Bilby3D Pty. Ltd.
Sydney - Kingsgrove, NSW
Melbourne - Clayton, VIC
Perth - Belmont, WA
3D Printers
Bilby 3D Technical Support
3D Printer Service and Repair
Courses and Training
Materials / Filament
3D Scanners
Parts and Spares
Tools & Jigs