The TMC2208 is a high-performance two-phase stepper motor driver chip with a UART interface and a simple step/dir interface. It is very low noise with a high load driver to reduce lost steps.
Heatsink included!
FeaturesSpecsSupport
Advantages
Good heat dissipation - Large contact area to give good heat dissipation
Ultra-quiet, below 10dB - StealthChop can drive the motor to run very quietly
Avoid losing steps and shaking - SpreadCycle: The motor controlled in the PWM chopper mode operates more smoothly and without Jitter
Note: this is supplied in DIY form so it is a straight drop-in for regular RAMPS boards. To use it in UART mode, simply create a solder bridge between 2 contacts - instructions can be found easily with a web search.
Driver Chip: TMC2208-LA, German Made
WARNING: this is not an interchange for Flashforge drivers (they are mirrored pin orrientation).
On TOP veiew (photo 2) top left is GND, top right is DIR).
For full details see Https://github.com/bigtreetech
Dimensions: 20.4 x 15.3 x 20mm
Next >
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Technical Data Sheet
Micro Stepper Motor Driver Trimanic TMC2100 (raise XY)
Genuine Raise3D Spare Part
Used to drive the XY axis on the Raise N2 (the Z Axis are the same as the Extruder and upside down/ not interchangable!) This driver will also be compatible with other 3d Printers
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $15
Sydney - Kingsgrove, NSW
Melbourne - Clayton, VIC
Perth - Belmont, WA
3D Printers
Bilby 3D Technical Support
3D Printer Service and Repair
Courses and Training
Materials / Filament
3D Scanners
Parts and Spares
Tools & Jigs