Metallic is a structural colour change resin. It will change colour when you look at the model from different angles. For the the best effect, keep the surface you want to appear metallic parallel to the platform.

Next >

Printing Tips

• Shake well before use as pigment will settle
• Stir vat between prints with a plastic scraper
• Print time is different for each colour in this range
• Wear gloves, safety glasses and keep the space well ventillated.

Gold
• Exposure Time: 3.5 - 5 seconds
• Base exposure time: 35 - 50 seconds
• Lift distance for the first layer: 12+ mm
• Lift distance for subseqent layers: 10mm

Tech Specs:

• Cures with 405nm (UV) frequency light
• Harness: 85 - 90 Shore D
• Volumetric Shrinkage: < 2%
• Linear Shrinkage: < 1.2%
• Density: 1.08 - 1.25 g/cm³
• Flexure Strength: 68 - 72 MPa
• Elongation at Break: 7.8 - 9.3%
• Wash with: IPA (Isopropyl Alcohol) > 95% concentration

Storage:

• Store at room temperature (15-35°C), it will have higher viscousity at lower temperatures
• Keep sealed and away from sunlight whenever possible


Dimensions: 85 x 125 x 220mm


Next >

This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product

10% Bulk Discount available; Order 10 or more filament at once, Prepay for your order, Phone 1800-847-333 to order. Conditions apply.

Material Safety Data Sheet

Technical Data Sheet