Use to filter resin when pouring back into container of origin after use.
Pack of 25pcs

This high quality resin printer is designed for applications where very high resolution is essential, such as jewellry and dentistry.

Build size of 120 x 67.5 x 150mm

It can be hung on the Rasie3D DF Wash Z-axis with models in it for washing and drying.

This hydrometer measures the specific density of fluids

Genuine MakeX Resin Tank/Vat for the M-One, XGA and HD models.
This is the Flex Vat V2.
This breakthrough technology does away with the old silicon resin coated vats, which are easily damged and become cloudy after as few as 10 prints in the same spot.
Instead this tank had a flexible FET film, which lessens the load on the machine when peeling off the print after each layer, PLUS it is easily and (relatively) inexpensively replaced!
Each tank comes with 1 film pre-installed, and a spare for you to use later.

Assembly notes:
- Peel the protective paper of the perspex panel, this sits in the base piece with the perspex UP, so the lower piece is raised in the middle
- Place the tank itself on top, so the raised section pulls the film tight
- Add the fixing screw with spring - wound in about half way only

The DF Wash is the perfect companion to the DF2 UV Resin Printer

Harden your resin prints with this UV Curing cabinet by FlashForge

Aftermarket paper filter with mesh panels - pack of 10pcs.
Note that the mesh is very fine, and may separate out some pigments from the resin.