Please note that you need a SuperVolcano Harden Steel Nozzle upgrade to print Carbon Fibre and other abrasive materials. Comes with a brass nozzle.

Faster
SuperVolcano boasts up to 11x the volumetric flow rate of the V6. Read more about just how quick it can print on our blog post.

High temperature
The SuperVolcano can reach 285°C with the supplied thermistor, by swapping your thermistor for a PT100 or thermocouple you’ll be able to exceed 400°C. Print anything from PLA to PEEK.

Full range of nozzles
Try out a range of nozzle materials and sizes. From extensive testing, we found using a 1.0 mm nozzle gives the best balance of speed and detail. But you have the option to choose from 0.6mm up to 1.2mm. Greater interlayer and bed adhesion
Print wider and higher tracks - this provides a greater surface area for these tracks to bond to each other and the bed, resulting in stronger prints with reduced warping.

Compatible with the E3D ecosystem
The SuperVolcano upgrade kit is fully compatible with the E3D HotEnd range. Attach with ease to your V6, Titan Aero, Titan Aqua, Chimera+ or Hemera.

Space for a second thermistor
If extra redundancy/monitoring of your HotEnd performance is what you are after, then feel free to add another thermistor into the equation (not that that’s required).

The supervolcano is a very tricky extruder to use. There are a few settings that can help Retraction - 3mm Disable wipe. It can be re-enabled after testing, set to 10mm is a good starting point Temperature - lowered compared to volcano, but depends on nozzle size extrusion multiplier - 0.99.9 to -0.99%, a slight under-extrusion helps with making things work properly Internal Infill Pattern - Rectalinear, it makes the least blobs Infill Extrusion Width Percentage - lower to 90-80%. it will extrude a thinner line only on the infill and cause fewer blobs

Next >