Glitter Flake has little risk of clogging or wearing your nozzle, and it won´t make a glitter mess, but beware, printing with glitter is sure to be addictive! Glitter particles will lay flat with smaller layers, giving top/bottom surfaces more shine than sidewall, so have some fun playing with resolution to see how the result changes!

Like other Proto-Pasta HTPLAs, Glitter Flake HTPLA can be Heat Treated to increase crystallinity for Higher Temperature resistance compared to amorphous PLA, ABS, and co-polyesters like PETG! Glittler Flake HTPLA prints translucence, but turns opaque when heat treated (or crystallized). With a more crystalline structure, HTPLAs Heat Deflection Temperature (HDT) can be practically elevated to 120°C (250F) or more depending on post-processing. Heat treated parts retain more stiffness to higher temperatures!

For this improved performance, your prints should be baked in an oven until you see a change from translucent to opaque with reduced gloss. This visual change indicating the improved performance! We´ve seen the change take place in 5-10 minutes on thin walled parts but can take an hour or more. We´ve had good luck in a quality, at home convection oven at 110°C (225F). Parts will get very floppy before becoming more firm, so please leave supports on your parts or support them and bake them on a flat, non-radiating surface (like glass, ceramic, or composite).

Usable on most PLA-compatible printers, such as Lulzbot, Makerbot, FlashForge, Dremel, Ultimaker, Printrbot, and more!
No abrasive fillers so expect normal wear with standard nozzles.

In our experience, good results were achieved using standard PLA parameters ranging from 190-230°C nozzle with standard build surface preparation (blue tape, glue stick, or BuildTak). No heated bed required but up to 70°C okay. Some shrinkage will occur in the heat treating process, so dimension critical parts may need to be scaled appropriately (as much as 2.5% in our experience).

Next > More Information

NON SPOOLED COIL : This is a sample coil. It comes bagged but not on a spool
Non-Abbrassive
For printing help see support tab
Length Aprox 17m


Dimensions: 158 x 150 x 13.6mm


Next >

For how to increase the temperature resistance of HTPLA, read our article on Post-Print Annealing https://www.b3d.com.au/Know/DisplayArticle.asp?ArtID=104This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product

10% Bulk Discount available; Order 10 or more filament at once, Prepay for your order, Phone 1800-847-333 to order. Conditions apply.

Material Safety Data Sheet

Technical Data Sheet