Prices + Stock updated 10 May @ 13:42
Extruder Board for the original Finder / Guider / Inventor 2 that used 12V heater cartridges. Will not work on a Jaycar finder, or Inventor 2s machines
Joins the large ribbon cable coming in to the extruder to all the connectors for extruder componants (the motor, sensors and heater cartridge) in the extruder
Note: Current version is marked 0.6 > photo shows version 0.3
Next >
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Related Products:
Buy Now
Extruder Flat Cable for FlashForge Finder / inventor 2
This cable comes out of the body of the machine and runs to the extruder.
Buy Now
Extruder Motor Cable for Flashforge Finder and Inventor 2
Genuine flashforge Spare Part - extruder Motor Jumper - runs between the extruder stepper motor and the extruder board
Buy Now
FlashForge Guider2/2s Extruder Board
Genuine FlashForge Replacement Part for the Guider2 and Guider2s. It compatible with 24V heater cartridges
Buy Now
Extruder Flat Cable for FlashForge Guider2 + Creator3
This cable comes out of the body of the machine and runs to the extruder.
Copyright 2011-2024 Bilby3D Pty. Ltd.