0.4mm Nozzle for FlashForge Creator Pro 2-CP2-includes PTFE tube
Genuine standard brass nozzle for the FlashForge Creator Pro 2 M7 Thread, 9mm Head size
4mm hole Recessed For PTFE tube of 28.2mm
FeaturesSpecsSupport
Next >
M7 Thread = 9mm long
Total length = 16mm
9mm head width (across the flats of the hex)
Internal diameter = 4mm for PTFE tube
PTFE Tube recessed 4.5mm inside threads
Ptfe tube
2mm inner -4mm outer = 28.2mm length (possibly should be 28.5mm)
Now includes PTFE tube
Product Dimensions: 16 x 9 x 9mm
Next >
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
0.4mm Nozzle - MicroSwiss Twin-Clad for Creator Pro 2-CP2
Brass Plated Wear Resistant Nozzle for Flashforge Creator Pro 2 made by MicroSwiss in the USA
Buy Now
0.6mm Nozzle - MicroSwiss Twin-Clad for Creator Pro 2-CP2
Brass Plated Wear Resistant Nozzle for Flashforge Creator Pro 2 made by MicroSwiss in the USA
Buy Now
0.8mm Nozzle - MicroSwiss Twin-Clad for Creator Pro 2-CP2
Brass Plated Wear Resistant Nozzle for Flashforge Creator Pro 2 made by MicroSwiss in the USA
Buy Now
Heater Block for FlashForge Creator Pro 2 (IDEX)-CP2
Genuine FlashForge Heat block for the Creator Pro 2 (IDEX) - Left and Right identical
Buy Now
Barrel for FlashForge Creator Pro 2 (IDEX)-CP2
Genuine FlashForge Part for the Creator Pro 2 (IDEX)
Buy Now
FlashForge Heater Cartridge for the CreatorPro2-CP2
Genuine FlashForge spare extruder heater for the Creator Pro 2.
Fits both left and right extruders.
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $15