Very similar to BuildTak, it gives unrivalled performane for getting items to stick to the bed for less warping and less print failures.
At 165x155mm, this tape is also a great size for an Da Vinci Jnr, UP Plus 2 or UP Mini and is compatible with a heated bed.
We have tested this bed surface with PLA, ABS, Nylon and PETG.

Tip: When removing the old tape, the glue is very aggressive. We recommend pre-heating to 80-100°C Peel off the old tape and use it side down) to wipe off any remaining glue. Allow to cool before fitting new sheet

Next >

165 x 155mm, 0.6mm thick with the self-adhesive backing paper still on

Dimensions: 165 x 155 x 1mm


Next >

Please clean with a clean cloth, a damp cloth, or slightly soapy cloth (then make sure you get all the soap off!).
Acetone or IsoPropyl Alcohol will ruin this surface - DO NOT USE!This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product