Prices + Stock updated 10 May @ 13:42
Drop in replacement for the motherboard found on most (pre RasberryPi / OctoPrint) machines. Supplied with the Unified Firmware (Legacy Models), other firmware and instructions, please see the Printrbot website.
Outputs for 4 motors (X,Y,Z, and Extruder), Extruider and Bed Heaters
Inputs for X,Y,Z and E stops
Micro-SD Card slot and Micro-USB slots
This is the latest edition board with a 6 pin power connector. Note Rev D and earlier boardshave a 4 pin power connector and need a jumper cable 4-6 or 8 pin. Available seperately (product code ptPwr4to8pin)
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Copyright 2011-2024 Bilby3D Pty. Ltd.